Skip to content

Cir. 37/1974

Conical white metal rope cappels for winding

Department
Not stated
Year
1974
Collection
Regulation-wise digest (to 2017)
Under
CMR80 / MMR 88
In the DGMS Circulars (up to June 2017) compilation, p. 121.
Open PDF at page 121

6. Conical white metal rope cappels for winding—Reg. 80(5) (d) of the Coal Mines Regulations, 1957 specifies that the tapered portion of the socket shall not be less than 8 times the diameter of the rope. The matter was examined while according approval to indigenous manufacture of cage suspension gears and it was found that adherence to the above specification with adequate angle of taper in the basket of the cappel may not provide enough clearance in the opening of the detaching plate of safety hooks of smaller capacity. In order to obviate the problem without affecting the strength for capping it was decided that— (1) For ropes up to 26 mm diameter size the taper length of the basket of conical white metal type cappel shall not be less than 61/2 times the nominal diameter of the rope and for rope size bigger than 26 mm diameter the taper length shall be generally in accordance with the specification of the aforesaid regulation.

(2) The angle of taper in the basket of the socket shall not be less than 4l/2o.

The N.C.B. specification referred above specifies a taper length of about 7.3 times the diameter of the rope and angle of taper to about 41/20.

(Cir. 37/1974)

Reproduced from the official DGMS circular compilations for public reference. The PDF is the authoritative text; DGMS may have amended or withdrawn older instructions since.

← Search all circulars