Skip to content

Cir.Tech. 1/1980

Precautions with reliance type rope cappel

Department
Technical
Year
1980
Collection
Regulation-wise digest (to 2017)
Under
CMR 81/MMR 89
In the DGMS Circulars (up to June 2017) compilation, p. 134.
Open PDF at page 134

4. Precautions with reliance type rope cappel—In a recent incident during coal winding, the limb of 29 mm reliance type rope cappel slipped from the rope and the cage crashed at the pit- bottom. To prevent such accidents, the following measures are recommended :

(1) Examination while purchasing and while installing—At the time of purchase and before installation, a detailed examination should be carried out of cappel or other cage suspension gears. They shall be installed only after being fully satisfied of the quality.

(2) Cappel bands should not foul with detaching plate— The winding rope and detaching plate shall be co-axial during the entire winding cycle so as to ensure that the cappel bands do not foul with the detaching plate at any point during partial or full overwinding.

(3) Over-winding clearance— The overwinding clearance shall be adequate as indicated in Reg. 75(5) of CMR 1957 or Reg. 84(4) of MMR 1961. This space shall be checked afresh when any set of new suspension gears is installed, so as to ensure that the overwinding space is maintained.

(4) Maintenance of overwinding protection— The overwind protection when-ever required to be provided shall be suitably set and maintained in good working order.

(5) Damage to suspension gear—In case of any external object hitting the suspension gear assemblies, the entire set shall be immediately checked for any defect before continuing any further winding. Such checks shall also be carried out when there is any doubt of such external disturbance to cage gears particularly after lowering of long materials like wooden props, pipes etc.

(6) Supervision during installation/during examination—Supervision at the time of installation and subsequent examination of cage suspension gears when in use shall be done strictly as per statute. For the cappels it is important that the various dimensions of clearances between the wedges, between the white metal cone (safety block) and the bottom of the wedges, the distance between the first pressure band and the bottom of the wedge etc. etc. as observed at the time of installation and during subsequent re-capping and examination shall be correctly recorded in a bound register at the mine. Whenever any abnormality is observed, a proper investigation shall be carried out and suitable remedial measures taken.

All the existing winding installations should be checked in the light of these recommendations and suitable action taken.

(Cir.Tech. 1/1980)

Reproduced from the official DGMS circular compilations for public reference. The PDF is the authoritative text; DGMS may have amended or withdrawn older instructions since.

← Search all circulars