Skip to content

Cir. Tech. 4/1989

Reg. 81 Incidents related to over-travel of travelling block

Department
Technical
Year
1989
Collection
Regulation-wise digest (to 2017)
Under
Reg. 81
In the DGMS Circulars (up to June 2017) compilation, p. 674.
Open PDF at page 674

Reg. 81 Incidents related to over-travel of travelling block—1.0 In the recent past, a number of incidents occurred in which travelling block over-travelled thereby hitting either the crown block above or the rotary table below. Incidents of this type, apart from causing severe damage to equipment, are frought with serious danger to persons working on and around the rotary table platform and thus are a matter of great concern.

2.0 Enquiries into the incidents aforesaid revealed that:—

(a) The eddy current brake or the mechanical brake provided with draw-works did not function effectively.

(b) The spline clutch was not properly engaged as well as the clutch lever was not kept in locked position.

(c) At times-the operator failed, to operate safely due to lack of skill and experience.

3.0 In order to avoid such incidents, it is suggested that necessary steps be taken to comply fully with the provisions of Regulations 32(3), 32(4) and 81 of the Oil Mines Regulations, 1984.

It is also recommended that—

(a) operators shall be well trained so that they acquire adequate operating skill.

(b) any incident of over-travel shall be enquired into by the Safety Officer. The findings of enquiry shall be discussed at the meeting of Safety Committee and remedial measures taken to prevent recurrence of such incidents.

(c) suitable maintenance schedule should be adopted in respect of draw works and other associated machinery. If necessary, assistance of the manufacturer may be taken in drawing up such a schedule.

(Cir. Tech. 4/1989)

Reproduced from the official DGMS circular compilations for public reference. The PDF is the authoritative text; DGMS may have amended or withdrawn older instructions since.

← Search all circulars