Usage of portable hydraulic banding machine for recapping of Wedge type rope cappel
- Department
- Not stated
- Year
- 2010
- Collection
- Circulars 1995–2017
- Topic
- Circulars and notifications, 1995–June 2017
No.DGMS/(Tech.Cir.) No.04 Dhanbad 28/09/ 2010.
To The Owners, Agent and Manager Of all Coal & Manufacturers Mines Sub:
Usage of portable hydraulic banding machine for recapping of Wedge type rope cappel.
The wedge type cappel is one of the cage suspension gear components more commonly used in Mines. It is characterized by a pair of wedges, interlocked to ensure complementary movement and grooved to suit the particular rope diameter. A clearance between each half wedge allows progressive movement to retain the grip on the rope as the load increases. A number of bands, driven over the uniformly diverging exterior surfaces of the cappel limbs provide the initial compressive force to ensure that the wedges grip the rope. The limbs internal surfaces and the wedge backs are machined to provide a matching taper diverging from the cappel mouth. A safety block is white metalled on to the end of the rope protruding beyond the bottom of the wedges.
The operation of this type of cappel depends upon the friction (i) between the rope and the wedges, and (ii) between the wedges and cappel limbs.
The frictional forces developed at these surfaces of contact depend upon (i) the tightness of the bands on the limbs, (ii) the resistance of the rope to compression, and (iii) the angle of taper of the wedges.
For many years traditional method of banding and disbanding a wedge type cappel has been carried out by experienced strikers using sledge hammers. Numbers of skilled strikers are required to facilitate tightening of bands. Some times the sides of bands adjacent to the wedges shall never be struck. Burrs can also be caused during sledging of bands which may foul the wedges and retard their movement. Many a time bands get deformed and damaged due to sledge hammering. Experience have shown when the bands are driven on using the specified weight of hammers, the friction between wedges and cappel will vary and under extreme conditions the rope may tend to pull through the wedges.
M/s.Becker ( from United Kingdom) the originator of Wedge type of cappels had developed portable hydraulic banding machine for assembly/ disbanding operation instead of striking by hammers. The advantage of portable hydraulic banding machine is that sledge hammering on bands is avoided and ensures consistent pressure on every band for tightening. Further burring, deformation and damages to bands due to sledge hammering are avoided and hence longer life of the Cappel and rope. Accident due to flying off sledge hammer or slippage of drifts is also avoided. Banding & disbanding is much swifter compared & to sledge hammering operation. The same machine can be used for various sizes of ropes.
A schematic drawing of the hydraulic banding machine is being enclosed which may be altered or improvised as needed.
In view of the above, in interest of the safety the Portable hydraulic banding machines shall be used for safe banding and disbanding operations and discontinue sledge hammering to avoid damages to the cappel and rope.
It is requested to ensure that the above recommendation is strictly implemented.